Funded but Unreached: Mapping Energy Assistance Under-Enrollment in Refugee Arrival ZIP Codes
Photo: Internet Archive Book Images, No restrictions, via Wikimedia Commons
The bill after the lease
Energy assistance is usually debated as a funding question. For refugee settlement, it is also a map question. A family can sign a lease in a ZIP code with an active resettlement presence and still face a quiet housing risk: the first winter utility bill arrives in a name with no payment history, in a state whose application window may already have closed, in a building where the tenant pays for electric heat but the lease says utilities are included. The benefit may be funded. The question is whether it reaches the household.
The Low Income Home Energy Assistance Program, or LIHEAP, is a federal block grant administered by states, tribes, and territories. Eligibility is broad, but enrollment is not automatic. Reaching a benefit depends on outreach, application design, documentation, timing, landlord cooperation, and whether a household already has arrears. For newly arrived families, each of those steps can become a checkpoint. A map that shows only federal appropriations or state program totals will miss the neighborhoods where the assistance exists but remains unclaimed.
Why under-enrollment belongs on a settlement map
Refugee arrival geography is often drawn at the county or metro level, then interpreted at the neighborhood level. That gap matters for energy assistance. Resettlement affiliates place families in specific ZIP codes, but LIHEAP uptake is usually reported by state, county, or utility territory. Disconnection data is reported by utility, and utility service areas do not align neatly with ZIP boundaries. The result is a familiar mapping problem: the layer that describes need and the layer that describes reach are built on different geographies.
An under-enrollment audit does not try to prove that a particular household was denied. It asks a narrower, more reproducible question: in places where refugee arrivals are concentrated and energy burden is high, is LIHEAP participation lower than the surrounding area would lead us to expect? That is a coverage question, not a funding question. It is also a question advocates can answer with public data and a small number of local interviews, provided the method is transparent about what it cannot see.
Four layers, one question
A workable audit uses four layers. Each should carry a vintage date and a source note before it is drawn.
Layer 1: Arrival and service geography. Use resettlement affiliate service ZIP codes and county-level arrival counts rather than pretending that ZIP-level arrival counts are universally available. Where counts are suppressed, mark the ZIP as covered by a service area rather than assigning a precise number. Document whether the layer represents placements, arrivals, or active clients. These are not interchangeable.
Layer 2: LIHEAP reach. Use state LIHEAP dashboards, the HHS LIHEAP Clearinghouse, and administrative reports that break out recipient households, applications, and denials by county or ZIP where published. Normalize against an estimate of income-eligible households, not against total households. A high count of recipients in a large ZIP can still mean low reach.
Layer 3: Disconnection and arrears. Use public utility commission reports, municipal utility reports, and utility shutoff data where available. Prefer rates over raw counts and apply a reliability threshold. Small-cell suppression is not an obstacle to be worked around; it is a signal that the map should show a range or an unmapped category.
Layer 4: Energy burden. Use the Department of Energy's LEAD tool or ACS utility cost and income estimates to model the share of household income spent on energy. Treat the result as a modeled burden, not a household measurement. Pair it with tenure and heating fuel, because renter-occupied units and electric-resistance heat produce different risk profiles.
Constructing an under-enrollment flag
The central ratio is simple: LIHEAP households served divided by estimated income-eligible households. Compare that ratio to the state or metro ratio, then inspect ZIP codes where the ratio is low, energy burden is high, renter share is high, and refugee service presence is documented. Label the result a candidate flag, not a ranking. The purpose is to decide where to verify, not to declare a neighborhood the worst served.
Three distinctions should be kept visible. First, structural under-enrollment: the application is difficult, documentation is burdensome, or outreach does not reach the household. Second, timing mismatch: a family arrives after the standard application window or after crisis funds are exhausted. Third, utility-type mismatch: master-metered buildings, utilities included in rent, or accounts held by a landlord can make a household invisible to both the program and the map. Each distinction implies a different intervention.
What the map cannot say
This audit should not become a status surveillance tool. LIHEAP eligibility includes immigration-related rules, but mapping should remain aggregate and should not attempt to infer individual status from arrival geography. Do not treat arrival counts as household-level need. Do not compare raw enrollment totals across states without accounting for program variation, benefit levels, and application rules. Disconnection data lags, and utility territories cross ZIP lines. A clean map can still be wrong if those limits are buried in a footnote.
Questions for resettlement staff
- Which utilities serve our clients, and do we know their disconnection-notice process?
- Does intake capture the utility account holder, heating fuel, and whether utilities are included in the lease?
- Are we referring households before a shutoff notice, or only after one arrives?
- Do we track LIHEAP application outcomes by ZIP code, not just referrals?
- Who is responsible for households in master-metered buildings?
- Is there a language-access path through the state LIHEAP application?
Questions for utility navigators
- Which ZIP codes in our service area show high arrears but low LIHEAP participation?
- Does the state use categorical eligibility, and can enrollment in another benefit fast-track an application?
- Are crisis benefits available outside the standard heating-season window?
- Which documents most often stop refugee households: lease, income proof, Social Security number, or immigration documents?
- Can the utility share aggregate shutoff counts by ZIP code without exposing individual accounts?
A modest protocol for this winter
Before the peak of the 2026 heating season, publish a one-page map with the four layers and their vintages. Convene resettlement staff and utility navigators. Choose two flagged ZIP codes to verify through interviews and case review. Track application outcomes through the season, then update the map with a short methods note. The goal is not a national index of energy need. It is a repeatable local check that distinguishes a funded benefit from a reached household. That distinction belongs on the map.